close
close
Menu Close

How To Drill Out A Lock On A Vending Machine

th 217

How To Drill Out A Lock On A Vending Machine. Now you should have access to. The tape will serve as a depth guide to make sure you don't drill too deep into the lock and cause more damage to your machine.

Vending machine Refrigerators & Freezers New Bedford
Vending machine Refrigerators & Freezers New Bedford from www.facebook.com

I have had to drill out locks on vending machines before as i spent many years in the business. I had to use titanium drill b. Petaluma — on december 15th at around 2:30 am, an officer patrolling the petaluma factory outlets noticed a suspicious individual attempting to break into a vending machine.

This Makes Drilling Through The Screws Holding The Lock In Place Possible And Possibly Easier Than Drilling Out The Pins.

The cutting oil helps reduce the friction. Then go up in steps til you are around 3/8th inch, you should then be able to pry the lock itself out without damaging the lock assembly. Videos you watch may be.

After That, Wrap A Masking Tape Around A ¼ Inch Depth.

If playback doesn't begin shortly, try restarting your device. I successfully drilled out the lock friday, and am inside the machine. Now using a 1/4″ drill bit, place the drill bit in the indention you just made and drill out the center tab of the lock to a depth of 1/4″.

I Had To Use Titanium Drill B.

Some locks are stubborn and you may need to insert a screwdriver into the drilled out lock and twist to remove the housing, needle nose pliers can also aid the process. I was given this vending machine without any keys. How to fix a vending machine lock without drilling it out |.

Drill A Hole 1/4″ Deep Straight Into The Slot.

I have had to drill out locks on vending machines before as i spent many years in the business. If your medeco lock is made with a steel body, it might be easier to drill the pins out of the keyhole. How do you drill a lock out of a vending machine?

You Will Be Drilling A Hole Down The Center Of The Lock That Is 1/4 Inch Deep.

Any lock that is usually used for securing a vending machine, laundry machine or something with money or a service such as a gas meter, steering wheel locks, etc. I use the 1/4 size and aim my drill right for that little toungue that. We want to avoid having the machine tipping over and possibly breaking the globe.

Leave a Reply

Your email address will not be published.