close
close
Menu Close

How To Cut Led Lights And Connect Them

th 527

How To Cut Led Lights And Connect Them. Here is the video tutorial on how to install, cut and connect led lights strips. The following is a guide for cutting and splicing led rope lighting:

How To Solder LED Strips (The Ultimate Guide) KRM Light+
How To Solder LED Strips (The Ultimate Guide) KRM Light+ from newsstellar.com

Decide how you will connect the light to a power source. However, you will have to fit a new socket because cutting the led light gets rid of it. The ‘buckle’ on the connector keeps the strips in place once installed.

Decide How You Will Connect The Light To A Power Source.

The led strip lights come rolled on a spool. Once this is complete you ant to feed the four different coloured cord into their correct slots. At this point, you should check that they are not reversed by following the picture instruction.

Place The Light Strip Into The Connector.

Peel apart the wires an inch back. You can use these connectors to connect two strips together or even connect your led strip to the power supply. You simply have to install one end of your strip to the hippo buckle connector to connect two strips together.

You Can Strip These Wires Either Using Wire Cutters Or Scissors.

The next step will be to cut the special led light strip connector on one side so we can separate the wires and strip them. Remember that led lights are made to be cut, so you won’t receive a shock. From there, you can connect the leds to a power source either through a.

Each Led Has A Pair Of Copper Dots At The End.

Cut into the plastic right above the copper dots at the end of the led. You can find it at every 3 leds where there’s a line indicator surrounded by exposed copper spots on both sides. Make a small incision beside the led (in.

Here Is The Video Tutorial On How To Install, Cut And Connect Led Lights Strips.

Videos you watch may be added to the tv's watch history and influence tv recommendations. However, you will have to fit a new socket because cutting the led light gets rid of it. Use a sharp knife or box cutter.

Leave a Reply

Your email address will not be published.